ICS M4 AEG OD Stubby Silencer MA-19
Availability: In Stock
Manufacturer:ICS (I Chih Shivan)
- Compatible with M4/M16
- Slides over flashhider
- Full Review ICS M4 Quick Detachable Silencer
ICS M4 Quick Detatch (QD) Silencer
For the past few years, ICS M4 has been having great reviews. To make the rifle more fun to play with, why not add a little accessory to it. In this article, the ICS M4 Silencer will be discussed in depth to give the reader an insight of how this nice little accessory is a must have for the ICS M4 gun.
One of the latest M4 accessories is the QD Silencer
The silencer is also called the "suppressor." The name is interchangeable, but to most people it is well known as the "silencer."
There are many QD silencers out there in the market, but questions about it always come up: Is it sturdy? Will it wobble when used? What will it keep it from moving around? And are they just for looks, or does it actually do what it is supposed to do? Further in the reading, the ICS M4 Silencer will be reviewed giving answers to these questions.
The ICS M4 Silencer's First Impression: The first noticeable thing when the package is opened and taken out of the box is its weight and quality. It has a nice heft to it and seems to be manufactured with a better quality metal than those found on the SOCOM Suppressor. Having the dimensions of 41mm X 177mm, the solid piece of metal is quite impressive.
Markings are visible on some parts of this ICS M4 Silencer. One of them is "M4 QD CAL. 5.556" as shown in the image above. The second marking is the serial number shown on the left picture below. Lastly, the markings of the manufacturer's name as well as its location which is inscribed. They are "KNIGHTS ARMAMENT CO. Vero Beach, FL."
Attaching the ICS M4 Silencer: The silencer slides over an existing flash hider. It is held in place by two bars. It connects snugly onto the front of the gun by the inclusion of an O-ring in the rear cap. To note, QD in the name signifies "Quick-Detach."
The flat section at the bottom slides down and the silencer is slid over the flash hider. The connection fit is impressively tight. It can take a good bit of force to get it all the way inside the flash hider. The piece then has to press back far enough in order for the internal bars to line up with the rear groove on the flash hider. Then, press the sliding section back up and it snaps back into place.
Silencer Rear Cap: There has been occasions where the connection was popped open causing it to loosen when used during close-quarter battles. The reason is that the bottom piece is somewhat large. While this is not too cruicial for the accessory, it would help if it had a smaller bottom piece.
Build and Construction of the ICS M4 Silencer: As mentioned, the silencer is built with a high quality metal. It is has three separate parts: the rear cap, the inner tube, and the outer tube.
The outer tube is just a long metal cylinder with ported holes which gives it a nice touch in comparison to other silencers.
The inner cylinder is solid and unscrews from the front of the assembly. The interior of the tube is visible when the cylinder is removed. This comes
|Manufacturers||ICS (I Chih Shivan)|
|PreOrder Lead Time in Weeks||N/A|
|Battery & Charger Included||N/A|