Airsoft Press eBook Manual - Thorough Indepth Review on Airsoft AEG Rifle Upgrades - Step by Step Illustrated directions and tutorials - Perfect for Novice or Advanced Airsofters - A Must have for any player of the Airsoft Sport - Addresses Tokyo Marui, Classic Army, ICS, and other varieties of AEG Airsoft Guns - Contains over 130 Pages of Illustrations and Guides - Click on More Info for Table of Contents
Table of Contents
<< GETTING READY
Tools youâ€™re going to need
Proper handling of the screws
The proper ways of taking things
apart and putting them back together
TM AEG: a baseline for measurement
ACX versus Cybergun
ICS versus AE
What is proper usage?
<< HIGH FPS
What are the key
elements of a high FPS setup?
Version 2 mechbox versus Version 3 mechbox: any difference in
TM metal mechbox versus Cybergun plastic mechbox?
Are CA/ICS guns crappy for upgrade?
FPS increase in meter readings VS performance increase in a
practical sense: the law of diminishing marginal gain in
0.20g BBs versus 0.25g BBs versus 0.30g BBs: the heavier the
Does FPS always go hand in hand with Joule?
What is the difference between the FPS system and the Joule
How do you use FPS to measure Joule?
How do you use FPS to give an estimate of the range?
Higher FPS = lower ROF?
Softer spring = Higher ROF?
Harder spring = Lower ROF?
Is 8.4V insufficient for an upgraded mechbox?
Does battery size matter?
Is battery power important for semi-auto firing?
Is EG560 too weak and fragile to power an upgraded mechbox?
Can I use EG560 on my MP5?
Why (and why not) should I buy the high torque gear set?
Why (and why not) should I use helical gears?
Why (and why not) should I keep the stock plastic bushings?
Why (and why not) should I replace the stock plastic bushings with
What is an easy way to (more accurately) shim?
How do I tell if shimming has been done correctly?
Anything special about shimming the AR-15 mechbox?
What is the recommended order of gear insertion?
Longer spring versus shorter spring: the longer the better?
What are the major parameters of a spring?
Is a harder spring more harmful for the internals?
Installing a long spring: tricks and potential danger.
Installing a short spring: tricks and potential danger.
Why (and why not) should the spring be ground?
How to facilitate spring spinning?
What is a variable pitch spring? Is it always better for AEG?
Use of spacers for spring compression: tricks and potential
What is wrong with a custom made spring?
Systema Springs versus PDI Springs
Can stainless steel spring offer better FPS?
Can Telfon Coated spring offer better FPS?
The long variable-pitch spring is very difficult to install. What
should I do?
What can I do to reduce stress on the gears?
Can an EG1000 increase FPS (through higher torgue) over an EG700?
Why (and why not) should I use a Bore-Up Cylinder?
Why should I replace the stock cylinder on my MP5K / G3 SAS?