|
Basic maintenance
for AEG's
1.
Read the users manual before playing. Each AEG will have different operating
characteristics.
2. After playing, remove the magazine and switch to single
shot mode to release the spring within the mechbox. Finally disconnect
the battery ( Fig 1 ). Clean and lubricate your AEG before storage, as
needed.
3. Clean the inner barrel ( Fig 2 )and spray some silicone
onto the hop up after heavy use.
 Fig
1 Fig 2 Fig
3
Gas operate pistol basic maintenance
1. Read the user manual before playing, each pistol will
have different operating characteristics.
2. After playing, clean any dirt off the mechanisms, release
the remaining gas in the magazine. After cleaning, please lubricate in all areas indicated in figures 4-7
.
4. When filling gas magazines, the proper way to do it
is with the gas inverted. See user manual for your gas pistol for illustrations.
5. A 2 - 3 second charge with any type of gas is sufficient
( Too much gas will damage the magazine and/or the seals and thus cause
leakage.)
6. After repeated use the magazine may be very cold. This
will cause a decrease in power due to the gas not expanding correctly,
please wait 5 - 10 minutes to allow the magazine to warm up.
 Fig
4 Fig 5 Fig
6 Fig 7
Pressing trigger
with no response?
1. First, inspect the motor, has it overheated? If the motor
has overheated, please allow the unit to cool sufficiently. If not ( Fig
8 ), try a different battery, preferably a known fully charged battery.
If you can detect resistance within the motor like it's trying to turn
or can hear faint humming noises, disconnect the battery immediately to
prevent further damage to the AEG.
2. If motor diagnostic turned up negative, like the motor
was dead. Please check the battery connections( Fig 9 ) and motor connections
( Fig 10 ). Also check the fuse and see if it has burned out. ( Fig 11
).
3. If everything checks out from above and it is still
"dead". Then there could be other problems inside the AEG.
 Fig
8 Fig 9 Fig
10 Fig 11
What should you do when AEG's are jammed with a BB.
1. Use the unjamming tools that came with you gun. Insert
it into the barrel (Fig 12 )and push gently until the jammed BB comes loose. Note: Barrel does not need to be removed from gun before unjamming BB.
Afterwards reverse the tool and attach a clean strip of cloth, spray lubricant/cleaners
on the cloth and then insert into barrel to clear dust or dirt from the
barrel (Fig 13). Spray some silicone through it and wipe residuals one more
time.
2. Don't use any poor quality BB's, especially in tight
bore barrels!
3. If the AEG still will not feed or fire. There could
be a problem inside the unit or maybe in the gearbox. If you are new to
Airsoft or not experienced in repairing Airsoft items, please send the
item to one of our designated repair facilities.
 Fig
12 fig 13
Proper use of
AEG's
1. Excessively long firing in full auto will cause premature
wear inside the gearbox. ( Do not empty a hicap in one long burst! )
2. Firing in bursts is better for your gearbox, squeeze
trigger straight back, do not push trigger sideways for it will damage
the gear box.
3. After playing, please put AEG in safe mode or pales engage the safety ( Fig 16
).
4. Do not over charge your battery. Over changing batteries will result in reduced battery life and or battery damage. Click here to see example.
 Fig
14 Fig 15 Fig
16
|
