| Images/MetalSlide1.jpg" width="150" height="113"> |
Images/MetalSlide2.JPG" width="150" height="113"> |
Images/MetalSlide3.jpg" width="150" height="113"> |
| 1. Remove magazine by pushing down on magazine release |
2. Pull out magazine |
3. Cock gun by pulling back on slide |
| Images/MetalSlide4.jpg" width="150" height="113"> |
Images/MetalSlide5.jpg" width="150" height="113"> |
Images/MetalSlide6.jpg" width="150" height="113"> |
| 4. Gun in cocked position |
5. Place right forefinger on release button |
6. Pull slide back slightly. 7. Line up the release with the indentation on the slide |
| Images/MetalSlide7.jpg" width="150" height="113"> |
Images/MetalSlide8.jpg" width="150" height="113"> |
Images/MetalSlide9.jpg" width="150" height="113"> |
| 8. Push release out past the slide |
9. Pull out release |
10. Push slide forward |
| Images/MetalSlide10.jpg" width="150" height="113"> |
Images/MetalSlide11.jpg" width="150" height="113"> |
Images/MetalSlide12.jpg" width="150" height="113"> |
| 11. Remove spring and piston |
12. What you should be left with |
13. Unscrew two screws |
| Images/MetalSlide13.jpg" width="150" height="113"> |
Images/MetalSlide14.jpg" width="150" height="113"> |
Images/MetalSlide15.jpg" width="150" height="113"> |
| 14. Remove metal piece |
15. Remove barrel |
16. Remove plastic piece |
| Images/MetalSlide16.jpg" width="150" height="113"> |
Images/MetalSlide17.jpg" width="150" height="113"> |
Images/MetalSlide18.jpg" width="150" height="113"> |
| 17. Remove target sites on original slide |
18. Use screwdriver to punch out perforated holes of new slide |
19. New slide with holes |
| Images/MetalSlide19.jpg" width="150" height="113"> |
Images/MetalSlide20.jpg" width="150" height="113"> |
Images/MetalSlide21.jpg" width="150" height="113"> |
| 20. Place the target sites on new slide |
21. Place plastic piece on new slide |
22. Pull internal barrel out of original barrel
|
| Images/MetalSlide22.jpg" width="150" height="113"> |
Images/MetalSlide23.jpg" width="150" height="113"> |
Images/MetalSlide24.jpg" width="150" height="113"> |
| 23. Place internal barrel into new barrel |
24. Place new barrel into new slide |
25. Place metal piece in new slide and screw in |
| Images/MetalSlide25.jpg" width="150" height="113"> |
Images/MetalSlide26.jpg" width="150" height="113"> |
Images/MetalSlide27.jpg" width="150" height="113"> |
| 26. Replace Spring and piston |
27. Pull slide back slightly to line up indentation with release hole |
28. Put release back in and push past slide |