AEG Burst Wizard LV is a microcomputer controlled MOSFET switch system that also gives you burst firing capability. In addition, it gives you the sniper mode, LIPO battery protection and newly added Rate Of Fire (ROF) adjustment features. Airsoft instructional Video Guide Available.
- Microprocessor controlled MOSFET switch system that allows special burst mode firing. User selectable from 1 to 5 shots or more. The Burst Wizard has a timing resolution of 2 milli seconds. For a gun firing 25 RPS or (40 millisec per shot), you can tune the firing cycle time with 1/20th of 1 shot accuracy to achieve dead on shot count and most relaxed spring position.
- No modification to your AirSoft Electric Gun is required. No void of gun warranty issues. It is just in-line between your battery to motor connectors connection.
- Use it with all your gun collections. NOT JUST ONE.
- Extend the usage time of a trigger switch by preventing large current from the battery to go through it until the contacts have time to engage first (reducing arcing).
- Work with LIPO, NIMH and NICD batteries at voltages from 7.2VDC up to 16VDC and up to 80A.
- Enforce LIPO battery low voltage protection. Prior to disabling the firing function though, the gun will shake when the trigger is pulled to inform the shooter to change battery. The gun will stop firing when the battery reaches its critical voltage. (Support 7.4, 11.1 and 14.8V)
- User settable sniper mode for 1 second dead zone after each firing. This feature enhances the fairness and competitiveness of the game! The shooter has to aim the target much more accurately before pulling the trigger; otherwise the target may disappear before the gun can be fired again.
- Resume continuously firing mode if the trigger is pulled for more than 1 sec after last burst mode firing. (LV version allows option to lockout this feature)
- Soft starting of the motor every time the triggered is pulled. This feature extends the life of the gearbox and the motor by not driving them too hard but you won't feel any sluggishness at all.
- Active braking after firing (Burst mode only) to extend the life of the gearbox because of less wear and tear. This feature also ensures that the shot count be very accurate during the whole discharge time of the battery.
- Rate Of Fire (ROF) adjustment when the AEG Wizard is used in MOSFET switch mode settable at power up. This allows you to set your gun to fire at a rate that you like or for safety reasons.
- The AEG Wizard consumes very little power and will not drain your LIPO battery, which is bad, even if you leave it connected a week before a big game! As a matter of fact, it will take 120 days for the AEG Wizard alone to drain down a 2000mA hour battery! The normal leakage power just from the battery itself is more than the AEG Wizard.
- Announce the battery voltage so you know your battery is fully charged or 80% or 50% ...at the start of your game. Accuracy is +/- 0.1V (LV only)
VIDEO
FEATURES BURST WIZARD LV BURST AVOCADO COMMENT
ADJUSTABLE BURST COUNT 1 - 12 SHOTS Yes Yes LV Requires you to adjust the burst count at power up using a little philips screwdriver.
MAINTAIN SAME RATE OF FIRE AFTER INSTALLATION Yes No, noticeable slower Result of weak MOSFET used in Burst Avocado.
WORK WELL W/ ALL GEARBOX CONDITIONS Yes No, requires properly tuned gearbox to work well Especially If the pinion gear on the motor and the gear set is not perfectly tuned.
MOSFET GETS HOT AFTER 30 ROUNDS OF 1 BURST MOSFET slightly warm to touch Plastic case is very warm and the MOSFET itself is hot
SNIPER 1 SECOND DELAY MODE Yes No Burst Wizard allows you an option to enforce 1 second delay for next burst round firing.
RESUME TO FULL-AUTO OPTION Yes No Burst Wizard LV allows you to set the 1 second delay for resuming to full-auto option On/off at power up.
RATE OF FIRE CHANGE MODE Yes No Programmable 100% down to 40% at power up.
ANNOUNCE THE BATTERY VOLTAGE AT POWER UP Yes No Burst Wizard lets you know the voltage of your battery by shaking your motor at power up.
160A PEAK 80A CONTINUOUS CURRENT MOSFET Yes No, 65A Continous Burst Wizard King Kong & LV uses the best power and heat handling MOSFET package in the industry.
ARCHING PREVENTION TO PROTECT TAPPET PLATE Yes Yes Burst Wizard invented this feature first.
LIPO BATTERY PROTECTION Yes Yes Burst Wizard suports 14.8V too besides 11.1V & 7.4V LIPO.
